Din975 Flat Washer BS is important in many applications […]
Din975 Flat Washer BS is important in many applications where incompatible metals require compatible and secure connections. Place these pieces between incompatible pieces to make them work smoothly. This washer is also ideal for electrical insulation. There are flat shoulders, usually used in mechanical applications, can reduce vibration, while providing a strong corrosion resistance. These gaskets can be found in flanges or standard designs. Standard gasket gasket can be used for standard thread sizes.
Flat washer BS is usually made of natural-colored nylon; their designs are tough, although they seem insignificant, but they are designed to resist corrosion and various acidic chemicals. The flat washers are specially designed to tighten the outside of the screw but allow easy sliding on the screws. Once they are assembled, they will remain firm. Therefore, the assembly time is easy to reduce. If they wish to make progress, they must be available to domestic consumers and international customers.
The material and process of the fastened fastener are limited, and the fasteners of the bolts are not supported. Therefore, the surface of the connected member is protected by the compressive stress of the pressure receiving surface. Flat washers are mainly used to reduce the pressure, when some parts tighten the axial force is very large, easy to make the gasket into a dish, then you can use the material and improve the hardness to solve.
The anti-loose of flat washer BS effect is still relatively good. Note that the spring washer is a one-time, used to remove and do not reuse. Because the spring washer to rely on the edge of the nut on the nut to cut the role of the nut to prevent the reverse movement of the nut until the anti-loose effect. Once the nut on the spring washer is tightened again, the blade on the spring washer will be cut against the nut, and the edge will be blunt.